The strategy and tips for metal baler operation

Metal baler, metal shearing machine, hydraulic metal baler, heavy waste shearing machine, heavy scrap steel cutting machine operation strategy tips are here !

Jiangxi HL General Machinery Co.,Ltd have accumulated a wealth of research and development,production and field experience as well as continuous innovation. It can achieve a better crushing and extend the service life through some simple tips when using a multi-cylinder hydraulic cone.

1.Equipped with a buffer silo and variable frequency feeding equipment for the metal baler. Since the multi-cylinder hydraulic cone broken is using of laminating crushing principle, it requires uniform filling of the material and a large amount of feeding. Therefore, when installing and using the equipment, it is necessary to pay attention to the buffer silo in front of the equipment and ensure continuity of the material feeding. The feeding amount of equipment should be accurately adjustable and controllable. We recommended to install variable frequency feeding equipment to ensure stable feeding of the equipment.

2.Install the center feeding device. The multi-cylinder hydraulic cone breaking input and discharge is also an important factor affecting its crushing effect and service life. The equipment needs to be installed with a central feeding device to ensure its center feeding. The discharge of the equipment must be kept smooth to prevent the materials from being deposited under the equipment due to excessive moisture, excessive or excessive powder, and damage the equipment.

3. The metal baler shall be equipped with iron removing equipment and reverse check device for the belt conveyor. The correct configuration of the belt conveyor is also related to the good operation of the equipment as the belt conveyor is a device for feeding multi-cylinder hydraulic cones. Make sure avoid and proven the cone broken by the iron so the feeding belt conveyor should be equipped with iron removal equipment. And the backstop device prevents the material from falling too far when the feed belt conveyor stops, thereby reducing the trouble of the belt conveyor stopping the production.

0 replies

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published.